DUAL MOTOR DRIVER - 5 AMP

This is a ready to use dual H bridge module for controlling 2 DC motors with 5 Amp capacity each or a Stepper motor at max. 5 amp/phase. These motor drivers can be used to control any small to big motors. High speed PWM is also supported. It can be directly connected to 4 microcontroller pins to control 2 DC motor or a Stepper motor in Bipolar mode.

Features

• 5 Amp. per motor capacity
• Works with any circuit that gives 3 to 5 v high output
• Soft Start and Stop provides long life to gearboxes.

Usage

• Connect the 6 wires to circuits and 4 wires to Motors.
• Upon giving the battery/power supply to circuit it will drive the motors as per the input from RC circuit / Microcontroller / PC output or any other circuit that gives 3-5 V output.
• Pinouts:
  • Output section (Screwed connector)
    • Pin 1 : Motor 1 a
    • Pin 2 : Motor 1 b
    • Pin 3 : Motor 2 a
    • Pin 4 : Motor 2 b
  • Input Section (6 Pin male Header)
    • Pin 1 : Motor 1 + forward
    • Pin 2 : Motor 1 - reverse
    • Pin 3 : Motor 2 + forward
    • Pin 4 : Motor 2 + reverse
    • Pin 5 : +5 V output (For external circuits like MCU Board)
    • Pin 6 : GND

• Power Connector
  • Power Supply +
  • Power Supply -